quick tip
for best results
Fill the tray 3/4 full and allow to freeze. Top off and allow to freeze again.

step 1
Push one insert into the bottom of each cavity until you feel the roksTight seal snap into place. Firmly press all four corners of each insert into place.

step 2
Fill water to just below the top of tray and place tray in freezer on flat surface. Allow ice to freeze for a minimum of 8 hours.

step 3
Remove ice tray from freezer. While holding face down in the sink, run warm water on the silicone side of the tray for 10 seconds.

step 4
Let tray sit for 2 minutes and then push each ice cube out from the bottom of the tray. Insert may stick to ice cube.

step 5
Carefully remove insert from ice cube. A splash of water can ease this process.

step 6
Dry the ice tray and inserts fully before reassembling and storing for another round of roks.